Filter
Top Products
50
If you still want to aim at the satellite, press the
button to start the search.
After a change of location, the antenna moves to the last position selected. After initialisation, you will
therefore see the following display (example, as it depends on the last selected position):
If a signal is found, the antenna automatically goes into fi ne tuning mode (max. 90 seconds, if signal is
adequate the position is immediately saved).
For slight changes of location, the
antenna can fi nd the satellite very
quickly.
If no signal is found at the last position, the following message appears:
CHANGE OF LOCATION/TIMER PROGRAMMING
TIMER PROGRAMMING
To prevent the turntable rotating at a time when it is unsupervised or when rotation
might be irritating (e.g. in the middle of the night), a timer can be set. During the timer
period the turntable is active only if the UFS 740sw is in operation or is in standby
mode.
If the receiver is completely switched off (switched off at the power socket) and/or
the turntable is in park position, the turntable will be inactive during the timer period!
The same applies if during the fi rst movement the satellite position is not found.
See the UFS 740sw operating manual for details of how to program the timer. When using the
UFS 740sw on a CAP 600 please note the following additional instruction: