Filter
Top Products
Sat measurement
27
Example
You want to test the Kathrein matrix EXR 22. The command set for the
matrix EXR 22 is E0 00 24 (LNB High) and E0 00 20 (LNB Low).
Call up DiSEqC:
Press buttons [2ndF] [SAT-CTRL]
Press button [3] to call up the DiSEqC control.
SAT-CTRL menu
You can now enter the data bits for each code word using the buttons [0]
to [9] and [./S]. Send the control command by pressing [ENTER]. The >
symbol indicates that the control command has been sent.
DiSEqC menu
The command set to control the Kathrein matrix EXR 22 has been
entered and sent.
DiSEqC menu
Note
You can find the DiSEqC command sets for the Kathrein matrices
EXR 20, EXR 22 and the 9xx series in the Technical Appendix.
Overview of commands in Framing Byte
HEX
Byte
Description
E0 Command from master, single transmission
E1 Command from master, repetitive transmission
E2 Command from master, answer expected, first transmission
E3 Command from master, answer expected, repeated
transmission
E4 Answer from slave, "OK", no error detected
E5 Answer from slave, command not supported by slave
E6 Answer from slave, parity error detected
E7 Answer from slave, command not detected
SAT-CTRL LNB=1
V-SEC=2 DiSEqC=3
DiSEqC-Framing
DiSEqC-COMMAND
E0 00 24 >
0
+
ë