Filter
Top Products
Spectrum measurement
43
Spectrum measurement
To assess a receiving system you can display the frequency spectrum for
Sat, TV and FM on the screen.
You can call up Spectrum Measurement from the relevant mode (Sat, TV
or FM).
Command for Spectrum Measurement: [2ndF] [Spect].
Return to the normal LC display: 2 x [2ndF].
You can use the buttons [-] and [+] to move a cursor on to the level
graph to measure certain minimum and maximum levels. The frequency
and the measured value are indicated in the upper line on the screen.
The measuring range is indicated in dBµV on the axis on the left of the
screen. The level measurement range is set automatically.
The peak value of the level is measured in spectrum analysis.
Sat Spectrum
In the SAT mode (see relevant chapter) the entire Sat spectrum from 920
to 2150 MHz can be displayed.
LC display
TV Spectrum
The TV range (see relevant chapter) is subdivided into four sections,
which can be selected by pressing buttons [1], [2], [3] or [4]. See screen
and explanation shown below.
Example for UHF
SAT-Full