Filter
Top Products
SAT measurement
20
Locating Satellites
With the SCAN function, satellites, the exact transponder frequencies of
which are unknown, can be located. In doing so, the frequency range
from 1000 MHz to 2100 MHz is continuously scanned for received
signals. If signals are received, the reception level is displayed as a bar
graph. The measurement range may be adjusted to three different
sensitivity levels.
The level can be monitored with an acoustic signal, the pitch of which is
proportional to the received-signal level. The volume of the acoustic
signal can be adjusted with the volume regulator.
SCAN Menu
[2ndF] [SCAN] Changing over to SCAN mode
[-] [+] Change-over of the bar graph measurement range.
Level range 1: high input levels
Levelrange 2: medium input levels
Level range 3: low input levels
[2ndF] [2ndF] Exit
LC display:
• Level range 2: medium input level
• SAT mode
• Bargraph display
Example
Calling up SCAN mode:
• Press [2ndF] [SCAN].
• Move the antenna until there is a level tendency visible on the bargraph
display.
• Move the antenna until the maximum amplitude on the bargraph display
is reached.
• If necessary, diminish or elevate the sensitivity by pressing either [-] or
[+].
Exit:
• Press [2ndF] twice.
✐
LEV-Range:2 SAT
> ■■■■
À