Filter
Top Products
Adding/removing satellites
Adding/removing satellites
Setting up a satellite
The LNB can naturally also accommodate new satellites.
All new settings must be carried out from one digital programme position because
of the connected on screen displays.
For this, the orbit position that you need to take a bearing on must be known. The
“Antenna settings“ menu entry in the installation menu can be used as an aid for
alignment of the antenna.
Arrive to the menu item "LNB
configuration" via the main menu
M and
the „Installation“ - submenu with the
ou and O buttons (plus
password). Select this menu item with
O
and can then enter or select a new
satellite.
Remember that your system must be set-
up accordingly!
In the next step, move with
o u to
e.g. the entry „User1“.
After pressing the
- or + button, the on-
screen display appears shown opposite.
Confirm it with O.
The following message appears
Changes are being saved
One moment please
You can now make the entries appropriate to your receiving system in the corre-
sponding positions using the
o,u and - or + buttons and exit the menu by
pressing the
L button three times. At the same time, the new station data is
stored.
Make the alphanumerical entries using the numerical buttons on the remote con-
trol. For more information see section "operating instructions.
28