Filter
Top Products
Important Note on Initial Operation of the Receiver on a
UFO®micro System
10
Important Note on Initial Operation of the Receiver on a UFO
®
micro System
It is absolutely essential to carry out the following before and while registering receivers on the EXU 544
UFO
®
micro single-cable matrix:
- Connect the receiver to the TV set, but do not yet connect it to the UFO
®
micro ESU 32 outlet!
- You must first check the following settings on the “LNB Configuration” menu and
change them as necessary:
1. Press the
button to switch to the main menu
2. Press
to get to the installation menu and confirm your entry by pressing
3. Press
to get to the LNB configuration menu and confirm your entry by pressing
4. Press
to select the “ASTRA” satellite and confirm your entry by pressing
5. Press
to select “Tuner input” and press
to change the selection to "#1 & #2“
6. Press
to quit the set-up for the “ASTRA” satellite
You must run through steps 4-6 for each satellite received!
7. Press
three times to get back to the start screen
8. Interconnect the “LNB1 LOOP OUT” tuner output and the “LNB2 IN” tuner input by a coaxial
cable (F standard connector).
- Now carry out a UFO
®
micro reset on the receiver, as described below:
1. Press the
button to switch to the main menu
2. Press
to get to the installation menu and confirm your entry by pressing
3. Press
to get to the DiSEqC[UFO] set-up and confirm your entry by pressing
4. Press
to select the UFO option
5. On the UFO menu press
to select “UFO
®
micro”
6. Press
and change your selection to RESET by pressing
Confirm your selection by pressing
7. Press
to quit the UFO menu (press
to save your changes)
8. Press
three times to get back to the starting point
- Press
to switch the receiver to standby mode
- Now you can connect the receiver to the ESU 32 outlet
- Press
to switch the receiver on
- The registration is then performed automatically – the screen briefly shows: “UFO
®
micro active”
- Now perform a UFO
®
micro reset as described above (items 1-8).