Filter
Top Products
Adding/Removing Satellites
70
Adding/Removing Satellites
Satellite Setup
New satellites can of course also be added to the LNB configuration.
To do this, you must know the orbit position you need to aim at. The
“Antenna Setup” item on the installation menu can be used as an aid
in aligning the antenna.
To access the “LNB Configuration”, press
for the main menu, use
the
buttons to select the "Installation“ submenu and confirm with
(also entering your password, if activated). Press
to select
“LNB Configuration”, and you can enter or select a new satellite.
Note that your system must be configured accordingly!
In the next step, use the
buttons to move to the “User1” entry
for example. After pressing the
or
button, you are asked if you
want to add the satellite.
Confirm with
.
The following message appears:
Pay attention to the
bar at the bottom of
the on-screen display!
It provides guidance
on what to do next.
Note:
In two-cable systems
the tuner input must
be set to "#1 & #2".
The DiSEqC™ settings
must match the
installed reception
system.
In single-cable
reception select the
tuner input used.
Set Loop
when the
output of tuner #1 is
connected to tuner
in
p
ut #2 or vice versa.