Filter
Top Products
134
RECEIVER TO RECEIVER DATA TRANSFER
Your receiver is able to receive data from another receiver via its RS232 port. For this, the two receivers
are connected with a null modem cable. The transmitting receiver is the “master”, and the receiving
receiver is the “slave”.
The master and slave are both switched on. Then the RS 232 ports of the two receivers are interconnected
by a null modem cable.
Master:
Select “System Setup”, “STB Management”, “Transfer Channel Data”. Press the
button. Use
the
buttons to select “OK” and start the download by pressing the
button. The master
searches for the slave and, once it has found it, automatically begins downloading the channel list.
The following display appears: “Channel data being transmitted”.
Slave:
The following display appears: “Receiving data”. Once all the data has been received, fi rst remove the
zero-modem cable and then switch the receiver off and back on again at the power switch (hard reset).
You can now use the new channel data.
Not yet available in the current software version.
PREPARATION
CHANNEL LIST DOWNLOAD
DOWNLOAD OPERATING SYSTEM
Only possible between two UFS 822 receivers!