Filter
Top Products
75
You can programme a recording from the various views of the EPG (“Current”, “Programme list”,
“Highlights” and “Detailed information”) and from within their various sub-menus. When programming
recordings, the EPG automatically adapts to the actual SAT IF input signal mode (Single/Loop
through/Double Tuner). Example: If you are operating the UFS 821 in loop-through mode, you cannot
simultaneously record one programme on the ARD channel and one on the ProSieben channel, because
the two channels are not transmitted on the same transponder.
Use the cursor buttons (
) to select the programme you want and press the
(red) button.
The following display appears (example):
If there are no EPG data
available for the channel
you selected:
Select the channel for which you
want to programme a recording in the
“Current” view and press the
(red)
button. As there is no EPG data, you
must enter the data (date, start, end)
manually. Enter the data using the cursor buttons (
) and numeric pad. Press the
button
to save your settings.
You can set the automatic lead-in and
run-on times for your recordings in
the “User Preference”, “EPG Setup”
menu (see also the Chapters “User
Preference”, “EPG Setup”)
TVTV EPG AND TIMER
PROGRAMMING A RECORDING
You can use the
buttons to switch to the details on the next programme in the selected view.
Press the
button to return to the previous display, such as the programme list.
You now have a number of options to programme your recording. The settings are made using the
cursor buttons (
) and the numeric pad:
If a program on a protected channel is selected, you must enter the four-digit PIN
code (factory setting “0000”). The PIN can be changed by the user, as described
in the Chapter “Access control”.