Filter
Top Products
56
USER PREFERENCES
ONE-TOUCH RECORDING INFO WINDOW
Use the
buttons here to select the default recording time. If you forget to stop a recording you
started manually, it is automatically stopped by the receiver when the default recording time elapses.
You can choose a value between 30 minutes and 4 hours, in 30 minute increments.
DEFAULT RECORD DURATION
When you have made all the settings, press the
button to save them.
SAVE
On this menu use the
buttons to set the time at which you want the UFS 822 to update the EPG
data. The receiver (which must be in Standby mode) switches on from Standby, updates the data and
then returns to standby. Scheduled recordings do not affect this; the receiver then carries out the update
automatically later when recording is fi nished.
EPG GRABBING SETUP
Use the
buttons here to select whether to enable on-screen display of the
advanced recording settings on starting (press the
(red) button) or not. If you
select “Disable”, in manual recording mode, timeshift recording is automatically
started (see “Recording” section). Other recording modes are then excluded.
If you set the “EPG Grabbing” to “Off”, the tvtv EPG will not be updated at any time, and the existing tvtv
fi le will be deleted. The EPG then refers back to the SI data (EPG data) sent out by the channel providers.
If you set the “EPG Grabbing” back to “On”, you must fi rst update the tvtv data before you can use the
tvtv EPG again. To do this, press the
button to switch the receiver into standby mode and wait whilst
the update starts up and completes the process.