Filter
Top Products
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
ends.
• You can assign names to up to 30 FM/AM stations in all.
If you try to enter more than that, the station name stored the
earliest will be the first one erased.
• If you want to change the name of a station, first display the
name of the station (following steps 1 and 2 above), then
change the letter(s) that you want by following steps 3 and 4.
NOTE
You can assign names to radio stations with the Station Preset
Memory. Up to 30 stations can be assigned names.
Adjust the frequency to the station whose name you want to
enter.
This function cannot be available during the clock display.
Press the NAME.S button for at least two seconds.
"Name Set" is displayed once the station name preset mode is
entered.
The cursor will blink in the position where letters are entered.
Press either the 4 or ¢ button to move the cursor to the
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
Each time the COL button is pressed, the characters to be
entered change as listed below.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.
Continue steps 3 and 4 until all the characters are chosen for
the name.
You can enter up to 8 characters for each name.
Assigning Names
Press the NAME.S button.
The name of the station is stored in memory, and the Station
Name Preset mode ends.
6
NOTE
5
Alphabet (upper case):
A ~ Z
Alphabet (lower case):
a ~ z
Numerals/Symbols:
0~9 / + – * & " ° ' = < > [ ]
4
3
2
NOTE
1
Station Name Preset (SNPS)
Tuner features
— 12 —
English
You can change the display used when listening to the radio.
Changing the Display:
Each time you press the DISP button, the display changes as
follows:
Station frequency
SNPS name (only when being preset)
Character
Clock
Switching Display for Tuner