Filter
Top Products
Settings
27
ê›Å@íËÅ@ï“
Chapter 2: Various Setups
Operation procedure
1.
Set the mode switch of the joystick remote to the
Purple position.
2. While the player is in stop mode, press
SET UP
1
and
tilt the joystick up or down to display the "SOUND"
menu of "SET UP MENU".
3. Press
ENTER
to open the setup menu.
4. In the setup menu, select "Digital Audio Dolby
Digital" by tilting the joystick up or down and
press
ENTER
.
7
Bitstream
7
PCM
7
Digital Audio
Dolby Digital
Speaker Setting
Audio During Search
Dynamic Range Control
Audio Filter
DTS
MPEG
PCM Down Conversion
5. Select the audio output by tilting the joystick up or
down, and press
ENTER
to enter the selection in
memory.
"Digital Audio DTS" Setting
When a DVD or DTS-CD recorded in DTS is played,
this setting makes it possible to select the audio signal
output from the digital output connector.
At the factory, the player has been set to "Bitstream"
to enable digital connection to an AV amplifier with
built-in DTS decoder. Change the setting to "PCM"
when the digitally connected amplifier does not
incorporate the decoder.
Setting items
"
" : Select to return to the previous screen.
"Bitstream" : The signal is output as a bitstream.
Select when connecting a component containing
DTS decoder.
"PCM" : The signal is converted onto 48 kHz
(2CH.) PCM signal before being output. Select
when connecting a component without DTS
decoder.
Operation procedure
1.
Set the mode switch of the joystick remote to the
Purple position.
2. While the player is in stop mode, press
SET UP
1
and
tilt the joystick up or down to display the "SOUND"
menu of "SET UP MENU".
3. Press
ENTER
to open the setup screen.
4. In the setup menu, select "Digital Audio DTS" by
tilting the joystick up or down and press
ENTER
.
7
7
Bitstream
7
PCM
Digital Audio
Dolby Digital
Speaker Setting
Audio During Search
Dynamic Range Control
Audio Filter
DTS
MPEG
PCM Down Conversion
5. Select the audio output by tilting the joystick up or
down, and press
ENTER
to enter the selection in
memory.