Filter
Top Products
Settings
14
Chapter 2: Various Setups
This chapter describes the setup operations of the player according to the connected components. Most of the operations described below can be performed using the
provided joystick remote control unit. For the operations, also refer to the separate "User's Guide".
Chapter 2: Various Setups
Preparation of Remote Control
Unit
Installing the batteries:
Open the cover and insert the batteries (R6/AA) by
observing the polarity marking.
\ \
2
1
Remote control range:
6m
30° 30°
@
¶ When the controllable distance of the joystick
remote reduces, replace both batteries with new
ones.
Turning Power on
When the power plug of the player is inserted in a wall
outlet and the POWER button is pressed, the
"STANDBY" indicator lights up to indicate that the
power of the player is in standby mode.
1. Turn on the connected components and set the am-
plifier for the DVD player input.
2. Press
POWER
on the joystick remote to turn the
player main unit on.
¶ When the "STANDBY" indicator is lit, the power
of the player main unit cannot be turned on by
pressing the POWER button on the main unit.
(To turn the power of the player main unit on it,
press the 3 button.)
3. The player's tray starts rotation to detect if any disc
is inserted, and the display shows "MECHA INIT"
(Mechanism Initialization).
4. When no disc is inserted, the display shows "NO
DISC" and the player enters stop mode.
¶ If there is any disc inserted in the tray at the
moment the power is turned ON, playback of
the disc starts automatically. If you want to
perform setups, press the 7 STOP button on
the joystick remote or the 7 button on the player
main unit to stop the player. The setup
operations are not available while a disc is being
played.
STANDBY mode:
While the "STANDBY" indicator of the unit is lit, a
small amount of current is flowing into the unit’s
internal circuitry to back up the memory. This
condition is referred to as the standby mode of the
unit. While the unit is in the standby mode, it can be
turned on from the remote control unit.
[
When you are going to leave the listening room
]
When the power is on or standby, it can be turned off
by pressing the POWER button on the player main
unit. (The "STANDBY" indicator does not lit in this
status.)
If the joystick remote is used
outside this area, correct
operations will not be possible.