Kenwood DVF-R7030 DVD Player User Manual


 
General Knowledge
42
Chapter 3: Other Information
Caution on condensation
Condensation (of dew) may occur inside the unit when
there is a great difference in temperature between this
unit and the outside.
This unit may not function properly if condensation
occurs. In this case, leave the unit for a few hours and
restart the operation after the condensation has dried up.
Be specially cautious against condensation in a
following circumsatance:
When this unit is carried from a place to another across
a large difference in temperature, when the humidity
in the room where this unit is installed increases, etc.
Transport or moving precautions
When transporting or moving the player, first remove the
disc and observe the following procedure.
1. Turn the player power on.
2. Wait for a few seconds, until the display shows "NO
DISC".
3. Turn the player power off by pressing
- ON OFF
POWER
.
DTS disclaimer clause
DTS Digital Surround™ is a discrete 5.1 channel digital
audio format available on CD, LD, and DVD software
which consequently cannot be decoded and played
back inside most CD, LD, or DVD players. For this
reason, when DTS-encoded software is played back
through the analog outputs of the CD, LD, or DVD
player, excessive noise will be exhibited. To avoid
possible damage to the audio system, proper
precautions should taken by the consumer if the analog
outputs are connected directly to an amplification
system. To enjoy DTS Digital Surround™ playback, an
external 5.1 channel DTS Digital Surround™ decoder
system must be connected to the digital output (S/P
DIF, AES/EBU, or TosLink) of the CD, LD or DVD
player.
This unit is equipped with DTS Digital Surround™
decoder.
Location: Laser Pick-up Unit Cover inside this
product
CAUTION- LASER RADIATION WHEN OPEN.
DO NOT STARE INTO BEAM.
CAUTION (For the U.S.A.)
Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
In compliance with Federal Regulations, following are
reproductions of labeles on, or inside the product relating
to laser product safety.
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI,
TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS
EQUIPMENT CONFORMS TO DHHS
REGULATIONS NO. 21 CFR
1040.10, CHAPTER 1, SUBCHAPTER J.
Location: Back Panel
FCC WARNING (For the U.S.A.)
This equipment may generate or use radio frequency
energy. Changes or modifications to this equipment
may cause harmful interference unless the
modifications are expressly approved in the
instruction manual. The user could lose the
authority to operate this equipment if an
unauthorized change or modification is made.
NOTE :
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment may cause harmful
interference to radio communications, if it is not
installed and used in accordance with the
instructions. However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
–––
Reorient or relocate the receiving antenna.
–––
Increase the separation between the equipment
and receiver.
–––
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
–––
Consult the dealer or an experienced radio / TV
technician for help.