Filter
Top Products
18
DVR-605/DVR-6100/DVR-6100K (EN)
Operations
Let's put out some sound
Preparation
÷ set the POWER switch to the ON ( ) position.
POWER
-ON/–OFF
POWER
INPUT
SELECTOR
VOLUME CONTROL
POWER
VOLUME
MUTE
INPUT
PHONES
Basic use method
Selecting the desired input
Volume adjustment
1
2
Muting the sound temporarily
Listening through headphone
REMOTE
REMOTEMAIN UNIT
To decrease To increase
To decrease
To increase
Remote control unit only
÷ Press again to resume the original volume.
÷ The sound muting is also cancelled when the volume is con-
trolled.
÷ Press the MUTE key.
Insert the headphone plug into the PHONES jack.
÷ The sounds from all speakers are cut off.
÷ When one of the keys on the left is pressed while STANDBY
mode, the power will be switched on automatically and the input
will be selected.
÷ The power will be switched on and the respective operation will
be performed also when the OPEN/CLOSE key, the PLAY/
PAUSE key or the BAND key on the main unit is pressed during
STANDBY mode.
÷ When a disc is set in the disc tray and the DVD CD key is pressed,
disc playback will start automatically.
In case of operation with the remote control unit, first select
the input or device to be operated with the INPUT SELEC-
TOR keys then perform the desired operation.
The present mode of the remote control unit may not
coincide with the equipment to be operated.
VOLUME
This unit offers various surround modes, but it switches
automatically to stereo mode when headphones are connected.
To open the door, pull the lower part on the right side of the
main unit.
SAT
CABLEVCR
TUNER
BAND
DVD/CD
FRONT
AUX
INPUT
+
–
VOLUME
MUTE
PHONES
1 Tuner (frequency display)
2 VCR (VCR → ANALOG → VCR)
3 SAT/CABLE (SAT/CABLE → AUTO → SAT/CABLE)
4 FRONT AUX (FRONT → OPTICAL → FRONT)
5 DVD/CD
Switching is done as follows when the INPUT key of the
main unit is pressed. (The parenthesized part shows an
operating example.)
The input mode can be switched with SAT/CABLE
and FRONT AUX.
Refer to “Changing the INPUT MODE” Y
Note
Note
MAIN UNIT
MAIN UNIT
Normally "MAX" is displayed when the volume settings set to
the maximum value.
If you have adjusted the speaker level above 0 db with the TRIM
key (R), "MAX" will not be displayed.
÷ When using the remote to select SAT or CABLE;
SAT (SAT
→ AUTO → SAT)
CABLE (CABLE
→ AUTO → CABLE)