Filter
Top Products
— 24 —
English
Audio effect control features
<When the KDS-P901 is connected>
Set the sound level of the each source selected by adjusting
the level difference between the basic sound level and the
required level.
Display and setting:
"Volume Offset" : - 8 – ± 0
4.Volume Offset
Adjust the Sub Woofer output level.
Display and setting:
"SW Level" : - 35 – 0 – + 5
• Not available during the Dual zone system is on.
• You cannot operate when the “Sub Woofer“ is set to “OFF“(
page 29 ).
NOTE
3.Sub Woofer Level
Adjust the fader level.
Display and setting:
"Fader" : Rear 15 – 0 – Front 15
2.Fader Level
Adjust the balance level.
Display and setting:
"Balance" : Left 15 – 0 – Right 15
1.Balance Level
Adjust various parameters of sound quality.
Hold down the AUD button for one second or more to enter
the control mode.
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the
adjustment modes.(Items 1-4 can be adjusted in this
Adjustment mode.)
Adjust each mode
Press the 4/¢ button.
Please refer to the following for the adjusting values.
Press the AUD button to end the control mode.
4
3
2
1
Audio Control Setting: