Filter
Top Products
— 26 —
English
Adjust the frequency of the Low-pass filter for Sub Woofer
output.
Display and setting the frequency:
"SW LPF" : 30Hz / 60Hz / 90Hz / 120Hz / 150Hz / 180Hz /
250Hz
7.Low-pass Filter for Sub Woofer Output
Adjust the delay time for sub woofer output.
Display and setting:
"SW DTA" : 0.0m / 0.1m / 0.3m / 0.4m / 0.6m / 0.7m / 0.9m /
1.0m / 1.2m / 1.3m / 1.5m / 1.6m / 1.8m / 1.9m /
2.1m / 2.2m / 2.4m / 2.5m / 2.7m / 2.8m / 3.0m /
3.3m / 3.6m / 3.9m / 4.2m / 4.5m / 4.8m / 5.1m /
5.4m / 5.7m / 6.0m
You cannot operate when the “Sub Woofer“ is set to “OFF“(
page.29 ).
NOTE
8.Delay Time for the Sub Woofer
Adjust the frequency of the High-pass filter for Centre output.
Display and setting the frequency:
"CNTR HPF" : THROUGH / 30Hz / 60Hz / 90Hz / 120Hz / 150Hz
/ 180Hz / 250Hz
Display and setting the slope:
"CNTR Slope" : 12dB / 18dB / 24dB
• You cannot operate when the “Sub Woofer“ is set to “OFF“
(page 29).
•You cannot operate when the “PCM Center“ is set to "OFF" (page
29) <When playing with the 2ch PCM signal>.
•You cannot operate when the “Multi CH“ is set to “2/2“ or “2/0“
(page 29) <When playing with multi-channels>.
NOTE
9.High-pass Filter for Centre Output
Audio effect control features
<When the KDS-P901 is connected>
Adjust the delay time for rear left output.
Display and setting:
"R-L DTA" : 0.0m / 0.1m / 0.3m / 0.4m / 0.6m / 0.7m / 0.9m /
1.0m / 1.2m / 1.3m / 1.5m / 1.6m / 1.8m / 1.9m /
2.1m / 2.2m / 2.4m / 2.5m / 2.7m / 2.8m / 3.0m /
3.3m / 3.6m / 3.9m / 4.2m / 4.5m / 4.8m / 5.1m /
5.4m / 5.7m / 6.0m
You cannot operate when the “Multi CH“ is set to “3/0“ or “2/0“
( page 29 ) <When playing with multi-channels>.
NOTE
6.Delay Time for the Rear Left Speaker
Adjust the delay time for rear right output.
Display and setting:
"R-R DTA" : 0.0m / 0.1m / 0.3m / 0.4m / 0.6m / 0.7m / 0.9m /
1.0m / 1.2m / 1.3m / 1.5m / 1.6m / 1.8m / 1.9m /
2.1m / 2.2m / 2.4m / 2.5m / 2.7m / 2.8m / 3.0m /
3.3m / 3.6m / 3.9m / 4.2m / 4.5m / 4.8m / 5.1m /
5.4m / 5.7m / 6.0m
You cannot operate when the “Multi CH“ is set to “3/0“ or “2/0“
( page 29 ) <When playing with multi-channels>.
NOTE
5.Delay Time for the Rear Right Speaker
Display and setting the slope:
"SW Slope" : 12dB / 18dB / 24dB
You cannot operate when the “Sub Woofer“ is set to "OFF" ( page
29 ).
NOTE