Filter
Top Products
— 25 —
Adjust various parameters of sound quality.
Hold down the XOVER button for one second or more to enter
the control mode.
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the
adjustment modes.(Items 1-12 can be adjusted in this
Adjustment mode.)
Adjust each mode
Press the 4/¢ button.
Please refer to the following for the adjusting values.
Press the XOVER button for one second or more to end the
control mode.
Not available during the Dual zone system is on.
NOTE
4
3
2
1
Crossover Network Control Setting:
Adjust the frequency of the High-pass filter for front output.
Display and setting the frequency:
"FRNT HPF" : THROUGH / 30Hz / 60Hz / 90Hz / 120Hz / 150Hz
/ 180Hz / 250Hz
Display and setting the slope:
"FRNT Slope" : 12dB / 18dB / 24dB
• You cannot operate when the “Sub Woofer“ is set to “OFF“
(page 29).
• The slope setting can’t be adjusted when the frequency setting
is THROUGH.
NOTE
1.High-pass Filter for Front Output
Adjust the delay time for front right output.
Display and setting:
"F-R DTA" : 0.0m / 0.1m / 0.3m / 0.4m / 0.6m / 0.7m / 0.9m /
1.0m / 1.2m / 1.3m / 1.5m / 1.6m / 1.8m / 1.9m /
2.1m / 2.2m / 2.4m / 2.5m / 2.7m / 2.8m / 3.0m /
3.3m / 3.6m / 3.9m / 4.2m / 4.5m / 4.8m / 5.1m /
5.4m / 5.7m / 6.0m
2.Delay Time for the Front Right Speaker
Adjust the delay time for front left output.
Display and setting:
"F-L DTA" : 0.0m / 0.1m / 0.3m / 0.4m / 0.6m / 0.7m / 0.9m /
1.0m / 1.2m / 1.3m / 1.5m / 1.6m / 1.8m / 1.9m /
2.1m / 2.2m / 2.4m / 2.5m / 2.7m / 2.8m / 3.0m /
3.3m / 3.6m / 3.9m / 4.2m / 4.5m / 4.8m / 5.1m /
5.4m / 5.7m / 6.0m
3.Delay Time for the Front Left Speaker
Adjust the frequency of the High-pass filter for rear output.
Display and setting the frequency:
"REAR HPF" : THROUGH / 30Hz / 60Hz / 90Hz / 120Hz / 150Hz
/ 180Hz / 250Hz
Display and setting the slope:
"REAR Slope" : 12dB / 18dB / 24dB
• You cannot operate when the “Sub Woofer“ is set to “OFF“
(page.29).
• You cannot operate when the “Multi CH“ is set to “3/0“ or
“2/0“ (page 29) <When playing with multi-channels>.
• The slope setting can’t be adjusted when the frequency setting
is THROUGH.
NOTE
4.High-pass Filter for Rear Output