Filter
Top Products
— 30 —
English
This item allows you to adjust the output level of each
channels of speaker using the built-in test signal.The output
level must be adjusted from the listening position.The factory
setup is “0 dB” for all types of speakers.
Test Signal:
Each time you press the 38 button to switch the noise
sequencer on and off.
Not available during the Dual zone system is on.
Adjusting the Front Right Speaker:
"CH LEV F-R" : -10dB – 0 – +10dB
Adjusting the Front Left Speaker:
"CH LEV F-L" : -10dB – 0 – +10dB
Adjusting the Rear Right Speaker:
"CH LEV R-R" : -10dB – 0 – +10dB
You cannot operate when the “Multi CH“ is set to “3/0“ or
“2/0“ (page 29 ) <When playing with multi-channels>.
Adjusting the Rear Left Speaker:
"CH LEV R-L" : -10dB – 0 – +10dB
You cannot operate when the “Multi CH“ is set to “3/0“ or
“2/0“ (page 29 ) <When playing with multi-channels>.
Adjusting the Center Speaker:
"CH LEV CEN" : -10dB – 0 – +10dB
• You cannot operate when the “PCM Center“ is set to "OFF"
( page 29 ) <When playing with the 2ch PCM signal>.
• You cannot operate when the “Multi CH“ is set to “2/2“ or
“2/0“ ( page 29 ).
• Not available during the Dual zone system is on.
NOTE
NOTE
NOTE
NOTE
10.Setting the Channel Balance
Audio effect control features
<When the KDS-P901 is connected>