Kenwood KVT-920DVD TV DVD Combo User Manual


 
67
External disc control mode
SOLUTION
POSSIBLE CAUSEPROBLEM
The following messages are displayed when certain problems are occurring in your system.
Take the recommended actions.
The protective circuit in the unit activates when the temperature inside the unit exceeds 60°C (140°F),
stopping all operation.
] Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls
below 60°C (140°F), the disc will start playing again.
Hot Error
The DVD software encoded for other region code.
Region code
Error
More than two DSP/EQUALIZER units are connected.
BUS-E11
More than two center units are connected.
BUS-E50
The disc player is malfunctioning.
] Eject the disc and try inserting it again. Contact the Kenwood dealer if this indicator continues blinking or
the disc cannot be ejected.
Mecha Error
The parental level is set to high levels.
Parental
level Error
The unplayable discs is inserted
Disc Error
The unit is malfunctioning for some reason.
] Press the reset button on the unit. If the "E- ##" code does not disappear, consult your nearest service
center.
Error 07
Error 17
Error 27
Error 37
Error 47
Error 57
Error 67
The disc is upside-down.
] Load the disc with the labeled side up.
The disc is quite dirty.
] Clean the disc, referring to the section on "Cleaning discs" (see p. 5).
Read Error
The computer chip in the unit is not functioning
normally.
Press the reset button on the unit (see
page 4).
The disc control mode cannot
be selected.
No cable has been connected to the disc
changer input terminal on the unit.
Connect the cable to the disc changer
input terminal on the unit.
The specified disc does not
play, but another one plays
instead.
The specified CD is very dirty. Clean the CD.
The CD is upside-down. Load the CD with the labelled side up.
The disc is loaded in a different slot from that
specified.
Eject the disc magazine and check the
number for the specified disc.
The disc is severely scratched. Try another disc instead.
The sound skips. Something is touching the disc changer. Remove whatever is touching it.
The CD is scratched or dirty. If skipping happens at the same place
when the car is stopped, something is
wrong with the CD. Clean the CD.
The display shows that the
changer is being played, but no
sound can be heard.
The specified track does not
play.
Random play or magazine random play has been
selected.
Turn off the random play or magazine
random play function.
Track repeat, disc repeat, track
scan, random play, and
magazine random play start by
themselves.
The setting is not cancelled. The settings for these functions remain
on until the setting to off or the disc
ejected, even if the power is turned off
or the source changed.
Cannot play CD-R or CD-RW Finalization processing is not being conducted
for CD-R/CD-RW.
Conduct finalization processing with CD
recorder.
A non-compatible CD changer is being used to
play the CD-R/CD-RW.
Use a CD changer compatible with CD-
R/CD-RW to play.