Kenwood VR-5090 DVR User Manual


 
22
Using Receiver
How Do I Adjust the Surround Modes?
Input Modes (only for input with digital jacks)
The input mode should usually be set to Full Auto. However, the input
mode can also be set manually when you want to fix the inputs as analog
signals, etc.
Full Auto : The receiver detects the input signal format and se-
lects the Listen mode automatically according to the
speaker setup.
Digital Manual : The inputs are fixed at digital signals and the listen
modes should be switched manually by the user.
The Digital Manual mode is switched automati-
cally to the Full Auto mode when an input is
switched or the receiver is set to Off.
Analog : The inputs are fixed at the analog 2-channel inputs.
6ch Input : The inputs are fixed at the analog 6-channel inputs.
This mode can be selected only when the DVD in-
put is selected with the input selector.
You cannot select the Input Analog mode if you are playing DTS-encoded
media.
When you use Full Auto mode with certain DVD and LD players,
performing operations such as Skip or Stop may momentarily
interrupt the output. This could switch the Listen Mode automati-
cally to the surround mode intended for the input signal if you have
manually selected a different listen mode.
Different input modes can be selected for the different input devices.
The selected input modes for the separate input devices are stored in
the memory.
When playing a DVD Audio disc with a DVD Audio-compatible DVD
player:
1. to reproduce stereo audio, set the input mode of the receiver to
6ch Input.
2. to reproduce multi-channel audio, set the input mode of the re-
ceiver to 6ch Input.