Kenwood VR-5090 DVR User Manual


 
26
Using Receiver
How Do I Adjust the Surround Modes?
To set the Listen Mode manually
The listen mode can be set manually except with certain input signals.
1. Press Remote Control units LISTEN M. button repeatedly until the
desired listen mode is displayed.
Listen Mode
Dolby Digital
Pro Logic
F.Auto
123
456
789
10 11 12
+10 0 +100
/8
/7
1
1
Operation on the receiver:
Press the LISTEN MODE button inside the door repeatedly until the
desired listen mode is displayed.
After 5 seconds, the display of the set listen mode returns to the previ-
ous display.
The available listen modes may be restricted depending on the input
signal and speaker setup.
When the input mode is set to Full Auto, if the incoming signal is not
Dolby Digital, DTS, DTS-ES or MPEG, the listen mode reverts to the
last listen mode you selected for that input.
When the speakers A are set to Off or speakers B are set to On, the
listen mode is switched to Stereo.
Different listen modes can be selected for the different input devices.
The selected listen modes for the separate input devices are stored in
the memory.