Filter
Top Products
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your Universal Room Controller
4
Table 1: RC-8IR Features
# Feature Function
1 Mounting holes (2) For fastening the controller in place
2 Faceplate Attachment Holes For attaching the faceplate to the controller
1
3 IR IN Receiver Accepts IR remote commands (for the IR-learner feature)
4 Configurable Control
Buttons (Macro Buttons)
Control the room and the A/V equipment (eight buttons)
5 RELAY2
6 RELAY1
Connect each relay to a room item (such as lighting, screen
settings, blinds, and so on)
2
7 RS-485 Terminal Block
Connector
Connect to the RS-485 detachable terminal block on a switcher or
PC
8 RS-232 Terminal Block
Connector (1 and 2)
Connect to the RS-232 connector on the A/V equipment or a PC or
other Serial Controller
IR OUT1 PIN
GND PIN Control up to 4 machines via IR Emitters
9
IR OUT2 PIN
10 GND PIN Connects (-) to the Ground
11 +12VDC IN PIN Connects (+) to the connector for powering the unit
Figure 2 and Table 2 define the RC-8IR rear panel:
Ethernet Port
Side View
Figure 2: RC-8IR Rear Panel
Table 2: RC-8IR Rear Panel Features
# Feature Function
12 N.U Switch Not used
13 PROGRAM Switch Switch to OFF for normal operation;
Switch to ON for firmware upgrade
14 RS-485 TERM. Switch Switch to ON for RS-485 line termination
15 FACTORY DEFAULT Button
Press to return to the factory default settings, including all the configured
buttons and the network settings
3
16 Ethernet Port Connects to a PC or other controller through computer networking
1 These screws should not be removed during or after mounting
2 See the examples in Figure 3
3 Including the factory default IP number: 192.168.1.39 (an IP number is a device's numerical address as expressed in the
format specified in the Internet Protocol)