Filter
Top Products
4. If Message 1 does not
appear after 30 seconds,
press the remote control’s
SAT button. Then press
the remote’s PWR button.
The receiver beeps twice
and its Antenna Power
light comes on.
5. If the receiver doesn’t respond, check the Voltage
status light on top of the receiver. If the Voltage
light is off, check the rear panel power switch. If
it is off, turn it on. The switch illuminates green.
This switch is normally left on at all times.
54-0287
2.3
Getting Started
2-1 Turning On the Antenna
To quickly start watching satellite TV using the
TracVision system, follow the simple steps below.
1. Apply power to the TracVision receiver.
2. Turn on your TV and select the satellite input (not
the VCR input).
3. Wait 30-60 seconds for the antenna to acquire the
satellite signal. The TV will show the following:
CAUTION
POWER
VEHICLE POWER
(10-16 VDC)
VHF ANTENNA
IN
AUDIO R AUDIO L VIDEO
S – VIDEO
PHONE JACK
RF
REMOTE
INPUT
OUT TO TV
TUNER
SATELLITE IN
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device must not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Tested to comply
with FCC Standards
TO SATELLITE
IN
TO KVH
ANTENNA
DIAGNOSTICS
PORT 1
DIAGNOSTICS
PORT 2
Installation
If your satellite dish is ready for DIRECTV
®
service, please wait until your
Advanced Program Guide
™
is prepared.
Searching for satellite signal...
Installation
If your satellite dish is ready for DIRECTV
®
service, please wait until your
Advanced Program Guide
™
is prepared.
Acquiring guide data...
Message 2
Message 1
Power Switch
PWR
DVD VCR AUX TV SAT
GUIDE
MENU
TURBO
FAV
N
E
L
I
N
E
G
U
I
D
Antenna Power Light
Voltage Light