KVH Industries TracVision R5 Satellite TV System User Manual


 
5-3
Maintenance
54-0157 Re
v
.
H
5.4 Field Replaceable Unit
Procedures
The following subsections provide detailed procedures for
repairing or swapping out field replaceable units. The procedures
refer to labeled items presented on the following diagrams.
PCB
PCB Cover
P
an Head Screws
Rotating Plate
RF Board
Standoffs
RF Board Cover
RF Cover
Screws
Figure 5-2
Close-up of Connecting Rod
and E-ring
Always lift the antenna unit by
the gray baseplate, never by the
radome or any portion of the
antenna assembly!
Figure 5-1
Antenna, PCB, and Rotating Plate
Antenna Gyro
(TracVision R5 only)
E-ring
Elevation Axis
Motor Shaft
Linear Actuator
Connecting Rod
The antenna reflector is not shown
in se
veral figures for clarity
pur
poses only
.
Do not remo
ve the
antenna reflector!
Before servicing the antenna unit,
be sure to remove the appropriate
vehicle fuse to disconnect power.
Replace the fuse after completing
the service.