Filter
Top Products
10
Antenna connection
Note: Before you connect something:
• To avoid every possible damage, turn off the TV-unit with Main Power Switch and then pull the power
plug out.
• Arrange the desired connection.
• When the connection made up firmly and correctly, connect the unit to 230V and turn the unit on.
Connect the antenna as shown below. Connect the unit with an outdoor antenna (G) or a cable-net (A). In
case of reception disturbance, consult with a specialist of antenna.
(A) Antenna connection: The built-in Hyperband CATV tuner can receive all analog cable television
programs.
(B) Variable Audio output: To connect with an audio amplifier and external speakers, and adjust the
audio level using the TV’s remote control.
To control the audio, turn on the TV and the stereo amplifier, and turn off the TV's built-in speakers
(see page 22).
(C) Scart sockets (AV1/AV2/AV3): To the connection of scart cables. See page 36 for AV4-Input.
(D) HDMI input: See page 31.
(E) PC Monitor input (PC): See page 29.
(F) Power supply: Connect the supplied power cable. Connect to 230 V / 50 Hz only. Never
repair a damaged AC power cord with isolation-tape. Have a specialist exchange with a new AC
power cord. Do not let your pet loose near the cable. To bite isolation is danger of life. Above all, a rat,
a parakeet, a hamster, a rabbit and other toothed animals can bite the cable.
(G) Outdoor antenna: If the outdoor antenna already exists, you can also connect to it for analog TV-
program.
(H) Bracket holes: To fix a wall mounting bracket (not supplied) here, remove the screws.
(C)(A) (B)
(F)
(E)
(G)
(H)
(D)
3U84011A [E] P02-10 20/12/05, 15:2110