Filter
Top Products
APPENDIX
72
APPENDIX
CLONING PROCEDURE TROUBLESHOOTING
• After cloning operations are complete, just unplug the LT2002 from the 26LH1DC3/4/5.
• If the 26LH1DC3/4/5 does not display a picture on the TV (blank screen) after a few seconds, just change channels.
Master and Other 26LH1DC3/4/5
8 Wait until procedure complete message is displayed.
Procedure interrupted.
8 Cloning is only possible with identical model TVs.
Different TV models.
8 Reread 54 - 55 - 56 pages to be sure all tasks were performed.
Step(s) omitted or not
performed.
8 Redo cloning and be sure learning/teaching time is about 1 min. and 5 to15 seconds (75 seconds).
Insufficient cloning time.
8 Reset Clone Programmer.
Cloning erratic.
Cloning did not work.
8 Batteries must remain installed to retain time settings.
Batteries were removed.
Clone time disappeared.
8 Disconnect newly cloned unit from power for 5 seconds.
26LH1DC3/4/5 not reset.
New Setup not present
8 Tr y a different LT2002 Clone programmer.
8 Reset Clone Programmer.
Clone programmer problem.
Clone not working
8 Retry cloning again.
Clone should only scan
channels once.
Clone Scans Channels more than once.