Filter
Top Products
16
206-4207
Set the TV features to the desired
configuration for the end user.
PICTURE
AUDIO
INPUT
OPTION
TIME
MY MEDIA
CHANNEL
LOCK
Audio Menu Note: Audio Menu
options are inaccessible (grayed out) if
TV Speaker is not selected (i.e., Pillow
Only is selected).
Lock Menu Note: Press 0-3-2-5 to
access the Lock Menu if the Lock
System is active and the password is
not available.
Custom Master TV Setup (Cont.)
Typical Installer Menu
Note: The Installer Menu header will vary
depending on the TV you are setting up.
Adjust the values for these
Installer Menu items.
Custom Master TV Setup Procedure
1. Set Installer Menu items.
This step provides specic instruction only on the Installer Menu
items that should be set on a Master TV. Refer to pages 19 to 26 for
detailed information on all Installer Menu items.
a) Make sure the TV is ON. Then, use the Installer Remote to
enter the PTC Installer Menu: Press MENU repeatedly until the
on-screen display of the TV setup menus no longer toggles,
and then press 9-8-7-6 + OK (Enter).
b) Set Installer Menu item 117 FACT DEFAULT to 001 and press
OK (Enter) on the Installer Remote.
This clears all Installer Menu custom settings, channel lineup,
etc. and reloads the factory default settings. The value will
change back to 0 after the PTC has been restored to factory
default condition. This step ensures that the TV Channel
Memory will be the active channel lineup.
c) Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 000. • HRC: Set to 002.
• CATV: Set to 001 (default). • IRC: Set to 003.
d) Set Installer Menu item 027 HOSPITAL MODE, as appropriate,
to select the speaker conguration.
e) Set any other Installer Menu items that affect your TV
programming network to the required conguration. For
example, enable/disable Aux inputs, set a Start Channel, etc.
f) After you have adjusted all Installer Menu item settings as
required, press OK (Enter) once on the Installer Remote to save
your changes; then, press OK (Enter) again to exit the menu.
2. Set up TV features.
On-screen setup menus control the features of the TV. Press
MENU on the Installer Remote to access the TV setup menus,
and then set Channel, Picture, Audio, Lock, Time, etc. options to
the desired configurations. See also Clonable TV Setup Menu
Features list on previous page.
Note: If you intend to clone the PTC, remember that only one TV
source’s clonable setup menu settings will be cloned. Thus, for a
clone programmer, the TV setup menu settings should be applica-
ble to either an analog channel or Aux input, while for a USB
device / .tll file, the TV setup menu settings should be applicable
to the analog or digital channel or Aux input to which the Target
TV will be set during the Teaching process.
Note: If desired and if appropriate depending on the cloning
method you intend to use (see “Cloning Methods” on previous
page), you can run Auto Tuning (see step 3) prior to completing
this step.
(Continued on next page)
117 FACT DEFAULT 000
003 BAND/AFC 001
027 HOSPITAL MODE 254
xxLQ630H PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC D279
PTC V1.00.013 CPU V3.07.00