Filter
Top Products
6
206-4207
Commercial Mode Overview
This document describes how to set up LQ630H and CQ610H TVs for Commercial Mode operation.
LG commercial TV functionality is based on “ownership” of the Channel Map; that is, the Channel Map
resides in the TV’s CPU, Protocol Translator Card (PTC), or embedded b-LAN™ (EBL) module, or it
resides externally from the TV (i.e., in a device from the solution provider).
Each of these TV models is capable of Free-To-Guest (FTG) Mode operation via the TV CPU. Alternatively,
the EBL module can be configured either for Pass-through Mode (default) or FTG Mode. When neither the
CPU nor EBL is in FTG Mode, these TV models also allow external control via the TV’s MPI port.
Setup Checklist
Note: This document provides information specific to Commercial Mode operation. Refer to the Owner’s
Manual for detailed information on TV installation and hardware and cable connections.
Installation
__ Unpack TV and all accessories.
__ Install batteries in the Installer Remote.
__ Install TV on VESA mount or stand.
Note: It may be advisable to make all cable
connections before installing on VESA mount
or stand, as appropriate.
Hardware Connections
__ Install any additional hardware as
appropriate to your institution, LAN, etc.
Cable Connections
__ Make all rear jack panel and MPI card slot
connections, as appropriate.
Commercial Mode Setup
__ Complete appropriate procedures as described
in this document for Commercial Mode operation.
Pass-through Mode
This mode allows you to configure stand-alone TVs and/or create a Master TV Setup for cloning purposes
for TVs that are to remain in Pass-through Mode. This mode also allows external control via the GAME
CONTROL/MPI port on the TV rear jack panel. There are two methods for configuring stand-alone TVs
in Pass-through Mode: either using the Express Script Installer Menu Wizard or the Custom Master TV
Setup procedure as described in this document.
Express Script Installer Menu Wizard
The Express Script Installer Menu Wizard guides you through the process of setting up the TVs, limiting
the customization of TV features and Installer Menu items to those that are essential to most hospital TV
viewing applications. The Express Script Installer Menu Wizard is described in detail on pages 11 to 14.
Note: While the Express Script Installer Menu Wizard enables you to set up TVs in lieu of cloning, you can
also use an Express Script TV Setup for cloning purposes, if desired. However, note that TV setup menu
customization via the Express Script Installer Menu Wizard is limited to Channel Menu options.
Custom Master TV Setup
Unlike the guided process above, the Custom Master TV Setup procedure enables you to create a
customized Master TV Setup for cloning purposes. Congure Installer Menu items as required for TV
operation and set up TV features (Channel, Picture, Audio, etc.). The Custom Master TV Setup procedure
is described in detail on pages 15 to 18.