Filter
Top Products
- 10 -
C
L
L
C
Finding center of the flat panel display
Once the flat panel is inverted, use a measuring
tape to find the center of your flat panel measuring
from outside to outside of the chassis. See figure 1.
Using a pencil lightly mark the center of your flat
panel.
See figure 2.
I
nverted flat
p
anel
Top of flat
panel
Bottom of flat
panel
Mark the center of
the flat panel
Measuring
tape
Inverted flat panel
WARNING!
INVERT THE FLAT PANEL PLACE IT ON A SOFT, FLAT SUFRACE TO PREVENT DAMAGE TO THE FLAT PANEL. USE A BLANKET, FOAM, ETC. FAILURE TO
DO SO WILL RESULT IN DAMAGING THE FLAT PANEL. DO NOT LAY THE FLAT PANEL ON THE FLOOR WITHOUT ANY PROTECTION TO THE GLASS. THE
FLAT PANEL IS HEAVY AND FRAGILE. AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR INSTALLATION OF THIS PRODUCT.
FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT PANEL.
WARNING : Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could
result in serious personal injury and possible damage to the flat panel.