Filter
Top Products
- 13 -
DIMPLES
FACING UP
DIMPLES
FACING DOWN
DIMPLES
FACING UP
DIMPLES
FACING DOWN
Securing the mounting brackets
The Griplates™ have M4, M5 M6 and M8 hole
patterns to fit the hardware that your flat panel
requires.
EXAMPLE: If your plasma uses M8 x 20 Phillip
screws. Use the M8 mounting points. See figure 7
Bottom of flat
panel
Phillips screw
driver
DIMPLES
M8
M6
M5
M4
Pre install two (2) M6 x 30 (mm) Phillip pan screws to
the bottom of the left and right hand side mounting
brackets. Once the mounting brackets are aligned secure
the Griplate™ to the flat panel.
NOTE: The dimples of the top plates have to be facing
up and the bottom dimples must be facing down.
Use (1) Griplate™ per mounting point. See figure 8.
NOTE: Secure the two (2) M6 x 30 Phillip pan
screws to the left and right mounting bracket.
CAUTION: Do not over tighten the mounting
hardware.