Filter
Top Products
- 8 -
Checking the thread depth on your flat panel
Inverted flat panel
display
Thread insert
Thread depth
indicator
Figure 2
Figure 3
Figure 1
Markin
g
the de
p
th
1. Insert the thread depth
indicator (supplied)
through the thread inserts
found on the back of the
flat panel to make sure the
inserts measure the same
full depth and mark it.
(see figure 1)
2. Locate the correct
diameter screw for the
thread insert. Compare
your marking to the
screws (supplied). If your
selected screw is longer
than the marking on the
thread depth indicator DO
NOT USE this screw.
The screw length must not
bypass the marking. Select
another screw size
(see figure 2 and 3). Until
you find one that comes
closest to your mark
without going past.
Marking
Screw
Marking
Screw
Thread de
p
th indicator
Thread de
p
th indicator