Filter
Top Products
- 2 -
- Assembly drawing - Securing the bottom wall plate
- Fine tune tilt adjustments - Securing the top plate
- Flat panel list - Securing the flat panel to the wall mount
- Parts list - Lateral shift adjustment
- Checking thread depth
- Finding the center of the flat panel
- Positioning the mounting brackets
- Securing the mounting brackets
- Finding the wood stud behind the wall structure
- Marking the bottom plate mounting points
Contents
WARNING: Safety precaution measures must be practiced at all times during the installation of this product. Use proper
safety gear and tools for the installation procedure to prevent personal injury.
The entire installation instructions should be fully read and understood, including all of the safety symbols and safety precautions,
before beginning installation. The installation instructions should be read, understood and followed to prevent personal injury or
property damage. Keep these installation instructions in an easily accessible location for future reference.
Indicates that the power plug is to be disconnected from
the power outlet.
Safety precautions must be taken at all times.
Contact Premier Mounts for any questions
Warning and caution in general
Do not install in locations where there is vibration, movement or danger of impact. Failure to do so could result in flat
panel cracking or falling from the wall causing damage and injury.
Do not install near heater, fireplace, direct sunlight or air conditioning or any other source of direct heat energy.
Failure to do so may result in damage to the flat panel and could cause a risk of fire.
At least two qualified people should always perform the installation work. Injury and damage can result from dropping
or mishandling the flat panel.
The wall structure should be capable of supporting a max weight of 160 Lbs., the weight of the flat panel. More than 160
Lbs the wall must be reinforced. Proper installation procedure by qualified personnel as outlined in the installations
instructions must be adhered to. Failure to do so could result in serious personal injury.
A secured structure wooden stud wall must always support the weight or load of the flat panel. Always confirm the
center of the wood stud before beginning the installation.
Mounting structure recommended wood studs, solid-flat concrete. Use a minimum diameter of 5/16” x 2 ¼” lg
concrete wedge anchors (commercially available). or a minimum diameter of 5/16” x 3” lg wood screws.