Lowrance electronic EP-80R Cable Box User Manual


 
15
3. Choose the desired temp sensor and press
ENTER. Select UNCONFIGURE
from the temp configuration menu and press
ENTER. The following
message will appear: Press Menu to UnConfig Device Name.
4. Press
ENTER to unconfigure the sensor. You will be directed to the
Bus Devices list where the temp now will be listed as UnCfg Temp.
Bus Devices highlighted in the System Setup menu (left). Searching
Bus Devices window (center) with Bus Devices list (right).
To reconfigure a temp sensor:
To reconfigure a sensor, there must be a configuration name available
(Water, Outside or Inside). If all temp sensor configuration names are
in use, you will have to unconfigure a temp sensor to make its name
available. If you try to reconfigure a sensor when the desired
configuration name is in use, a Name Already Selected message will
appear.
If all three temps are configured — meaning there is no configuration
name available, — follow the first set of instructions. If the desired
configuration name is available, follow the second set of instructions.
The first set of instructions below will show you how to switch the
configuration of a water temp to an outside temp.
If all temps configured (Configuration name unavailable):
1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
ENTER.
2. Highlight
BUS DEVICES and press ENTER. Select OUTSIDE TEMP and press
ENTER to open the temp configuration menu.
3. Select
UNCONFIGURE and press ENTER. The following message will
appear: Press Enter to UnConfig Device Name.
4. Press
ENTER to unconfigure the sensor. You will be directed to the
Bus Devices list. The Outside temp is unconfigured and will be
displayed as UnCfg Temp. Its configuration name (Outside) is now
available, so it can be used to reconfigure the Water temp sensor.