Lowrance electronic EP-80R Cable Box User Manual


 
9
To unconfigure a temp sensor:
1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES and press MENU, which will open the Bus Devices
list.
3. Select a temp sensor from the Bus Devices list and press
MENU. The
Configuration Options menu will appear with two choices: Unconfig
(Unconfigure) and Reconfig (Reconfigure).
4. Select
UNCONFIG and press MENU. The following message will appear:
Hit Menu to Unset Device Name.
5. Press
MENU to unconfigure the sensor. You will be directed to the
Bus Devices list, where the temp you unconfigured will be listed as
Uncfg Temp.
NOTE:
If your temp sensor is not updated on the Bus Devices list, refresh
the list by letting it time out and then access it again.
To reconfigure a temp sensor:
To reconfigure a sensor, there must be a configuration name available
(Water, Outside or Inside). If you try to reconfigure a sensor when the
desired configuration name (Water, Outside and Inside) is in use, a
Name Already Selected message will appear.
If all three temps are configured — meaning there is no name
configuration available — follow the first set of instructions. If the
desired configuration name is available, follow the second set of
instructions.
The first set of instructions below will show you how to switch the
configuration of a water temp to an outside temp.
If all temps configured (Configuration name unavailable):
1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES and press MENU, which will open the Bus Devices
list.
3. Highlight
WTR TEMP and press MENU, which will launch the
Configuration Options menu.
4. Select
UNCONFIG and press MENU. The following message will appear:
Hit Menu to Unset Device Name.