Filter
Top Products
6
ONYX FireWire Card
ONYX FireWire Card
7
Owner’s Manual
Owner’s Manual
Installing the Onyx FireWire Card
Important: Although the Onyx FireWire Card
has a protective cover on both sides of the
card, it does contain static-sensitive compo-
nents. Anti-static precautions are highly rec-
ommended before opening the anti-static bag
and handling the Onyx FireWire card. Use an anti-static wrist
strap when performing this installation. These are available
at most computer supply stores.
1. Turn off the Onyx mixer and remove the AC linecord from the socket on the
rear panel.
2. Remove the OPTION CARD blank plate on the rear panel by removing the
two screws using a #2 Phillips screwdriver. Save the screws for attaching the
FireWire card.
3. A 34-pin ribbon cable is attached to the back of the OPTION CARD plate with
a cable clamp. Carefully pull the plate away from the opening and slide the
ribbon cable out of the cable clamp.