Filter
Top Products
6
ONYX FireWire Card
ONYX FireWire Card
7
Owner’s Manual
Owner’s Manual
Set the blank plate aside. You won’t need it again, unless you want to remove
the Onyx FireWire card sometime in the future. Then you’ll want to reinstall
the blank plate.
4. Remove the FireWire card from the anti-static bag. CAREFULLY line up the
connector on the ribbon cable with the connector on the back edge of the
FireWire card and slide the connectors together, taking care not to bend any
of the pins. Note that there is an alignment tab on the top of the ribbon cable
connector that must align with the top of the connector on the FireWire card.
Top of Onyx FireWire Card
5. Slide the FireWire card into the slot. There are two supporting “legs” on the
back of the card. Angle the back edge of the card upward so the legs clear the
edge of the slot in the back of the Onyx mixer. Line up the two holes in the
plate with the screw holes in the back panel.
6. Secure the FireWire card in place with the two screws that previously held
the blank plate in place. Two more screws are provided with your FireWire
card. These go into the bottom of the Onyx mixer and secure the two support-
ing legs on the back of the card to the chassis.
7. That’s it! Now go enjoy a nice cold one before proceeding to the next section.