Filter
Top Products
31
Helpful Hints
No Power
• Check the TV power cord. Disconnect the power cord from
the power outlet for 10 seconds, then reinsert the plug into
the outlet. Press the STANDBY button to turn on the TV
again.
• Make sure the outlet is not on a wall switch.
• Make sure a fuse has not blown at the power outlet.
No Picture
• Check the antenna or Cable TV connections. Connect the
antenna or Cable TV signal securely to the TV’s 75 OHM
ANTENNA INPUT jack on the rear of the TV.
• Set TV/CABLE correctly. Details are on page 11.
• Activate AUTO PROGRAM to find all available channels.
Details are on page 12.
• Press TV/AV/EXIT on the remote control to select TV chan-
nels or a video source (VIDEO 1/S-VIDEO, VIDEO 2, or
DVD). Use VIDEO 1/S-VIDEO, VIDEO 2, or DVD to view
material on other equipment (Camcorder,VCR, DVD Player,
etc.) that is connected to the TV’s Audio and Video In jacks.
No Sound
• Press the VOL+ and VOL- buttons to adjust the volume.
• Press the MUTE button on the remote control to cancel or
restore the volume.
Remote Control does not work.
• Check the batteries. If necessary, replace them with two AAA
heavy duty (zinc chloride) or alkaline batteries.
• Clean the remote control as well as the remote control sen-
sor on the front of the TV.
• Check the TV power cord. Disconnect the power cord from
the power outlet for 10 seconds, then reinsert the plug into
the outlet. Press the STANDBY button to turn on the TV
again.
• Make sure the outlet is not on a wall switch.
• Make sure a fuse has not blown at the power outlet.
• Always point the remote control toward the front of the TV
(toward the remote sensor).
TV displays wrong channel or no channels.
• Repeat channel selection.
• Add the channel number(s) into the TV’s memory. Use
ADD/ERASE as described on page 14.
• Make sure TV/CABLE is set correctly. Details are on page 11.
Then activate AUTO PROGRAM to set up all available chan-
nels. Details are on page 12.