Filter
Top Products
114 EN114 EN
TROUBLESHOOTING
Symptom Remedy
GENERAL
Certain functions of the DVC cannot
operate.
• Some functions may not operate depending on the type of DVC. For
example, if the DVC does not support slow playback mode, the slow
playback function is disabled.
• With L3(DV-IN), the disc display menu does not appear unless disc
playback is executed.
DV audio signal cannot be switched. • For recording with the DVC, the recording audio signal can be set to 12
bits or 16 bits. However, when 16-bit recording mode is selected, audio
signal cannot be switched. To record an audio signal, set it to 12 bits.
No image from HDMI connection. • Check the HDMI connection. (Check the status of the HDMI related
indications.)
• Check whether the connected monitor device or other device supports
HDCP. (This unit will not output a video signal unless the other device
supports HDCP.)
• Check the setting of HDMI.
• Check whether the output format of this unit (HDMI FORMAT) matches
the supported input format of other connected device.
Setup menu cannot be called up. • Setup menus cannot be called up during DVD recording.
CHANNEL
TV channels cannot be changed. • Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Try channel setting by following the steps on pages 29-31.
Only specific channels do not appear. • The channels may be set to be skipped. (Refer to pages 30-31.)
The external input channels (such as
L1, L2 or L3) cannot be skipped.
• This unit does not skip the external input channels. This is not a
malfunction.
RECORDING
GENERAL
The image from the external device
cannot be displayed or recorded.
• Try pressing [SOURCE] repeatedly.
• Turn on all connected devices.
• Check if the connections are made securely and correctly.
HDD / DVD
Recording is impossible. • It is prohibited to make a recording from 2 minutes before the
programmed start time of a timer recording.
• This unit cannot record programs that contain copy protection signal.
This is not a malfunction.
• The space of the recording media may be used up. Try deleting
unnecessary titles, or exchange it with the recordable media.
• The maximum number of titles or chapters has exceeded. Delete the
unnecessary titles to make enough space or insert a new recordable media.
• Check if the connections are made securely and correctly.
Timer recording cannot be
performed.
• The internal clock of the unit may have been stopped due to a power
failure that lasted for more than 30 seconds. Reset the clock. (Refer to
pages 32-33.)
HDD
The picture of the autostart
recording disappears.
• The contents of the autostart recording will be cleared in some cases
(Changing input channel etc.). Refer to page 45.
When playing back the title
recorded from the autostart
recording, the DTV program
information is displayed and it
cannot be disappeared.
• In the autostart recording, when you display the DTV program
information, the information will be recorded as the part of the picture.
DVD
Recording is impossible. • Copy-once programs cannot be recorded on DVD. This is not a
malfunction.
• Check if the disc is protected or nalized. Undo the protection or the
nalization.
• DVD-RW once formatted on other unit cannot be recorded on this unit
unless all the contents in the disc are erased.
• Check if the connections are made securely and correctly.
The indication
“
Writing to Disc 100%
”
does not disappear.
• “
Writing to Disc 100%
” may remain on screen for the
maximum of 20 seconds even after it reached 100%. This is not a
malfunction.
E2S00UD_H2160MW9_EN_v1.indd 114E2S00UD_H2160MW9_EN_v1.indd 114 2008/11/20 12:58:292008/11/20 12:58:29