Filter
Top Products
English
36 Troubleshooting (Continued)
Symptom
Some channels are
skipped over when using
3/4
.
Picture and sound of
broadcasting channel are
weak or missing.
Camcorder image is not
shown.
Camcorder image via A/V
input to DVD+VCR is not
shown on TV screen.
Timer recording is not
possible.
indicator
appears after
DVD+VCR is turned off.
Stereo Audio Record
and/or Playback is not
present.
The "PROGRESSIVE
SCAN MODE" message
remains on-screen.
Cause
""
Those channels were deleted with the
CH. ADD/DEL option.
""
Antenna or cables are loose.
""
Wrong TUNING BAND option is being
used.
""
Camcorder is off. Ensure playback tape is
loaded properly.
""
DVD+VCR SOURCE SELECT is not set to
LINE1 or LINE2.
""
Clock in DVD+VCR is not set to correct
time.
""
Timer has been programmed
incorrectly.
""
indicator does not appear on
DVD+VCR after programming timer.
""
DVD+VCR is in Timer Recording mode.
""
TV is not Stereo-compatible.
""
Broadcast program is not in stereo format.
""
DVD+VCR A/V Out jacks are not con-
nected to TV A/V In jacks.
""
DVD+VCR Audio/Video Out is not select-
ed for viewing at the TV.
""
DVD+VCR BROADCAST TYPE mode is
set to SAP or MONO.
""
DVD+VCR was turned ‘ON’ while setting
the Progressive scan mode.
Correction
""
Use CH. ADD/DEL. to restore channels.
See “Channel Selection” on page 15.
""
Tighten connections or replace cable.
""
Try all TUNING BAND options. See
“Channel Selection” on page 15 for details.
""
Turn camcorder on and press PLAY to
operate properly. Re-check connections.
""
Press INPUT to select LINE input channel
(LINE1 or LINE2).
""
Set clock to correct time. See “Setting the
Clock” on page 16.
""
Reprogram Timer. See “Timer Recording”
on pages 22 and 23.
""
Reprogram Timer.
""
This is the normal indication that the
DVD+VCR is in TIMER mode.
""
No action is possible.
""
No action is possible.
""
Make A/V connections. Stereo is
available only via A/V output from
DVD+VCR.
""
Select AUX or A/V source as TV input.
""
Set BROADCAST TYPE mode to
STEREO. See “Setting the VCR Setup
Menu” on page 15.
""
Press and hold the STOP button for more
than 5 seconds to cancel Progressive mode
setting.
Moisture Condensation
Moisture condensation can occur:
•When the DVD+VCR is moved from a cold place to a
warm place.
• Under extremely humid conditions.
In locations where moisture condensation may occur:
•
Keep the DVD+VCR plugged into an AC power outlet
with POWER On. This will help prevent condensation.
• When condensation has occurred, wait a few hours for
the DVD+VCR to dry before using it.