Filter
Top Products
DVD to Videotape Duplication 41
Follow the steps below to copy a DVD to a videotape.
This will be possible only if the DVD is not copy protected.
Before you begin:
● Put a videotape in the cassette compartment. Make sure the tape’s
record tab is intact and the tape is long enough to record the
DVD.
● Put the DVD you want to copy in the disc tray.
● Press VCR so the red VCR light appears on the front of
the System.
● Turn on the TV.
1
Point the remote control at the System. Press Number
buttons 0, 0, 3. “DISC” will appear on the TV screen in the
top right corner briefly.The DVD logo will also appear.
2
Press MODE/SPEED until the desired tape speed (SP
or SLP) appears briefly in the lower left corner of the
TV screen. Details about tape speed are on page 77.
3
Press REC I to start recording. The red RECORD light
will appear on the front of the System.
4
Press DVD. Press PLAY B to play the DVD.
5
To pause the recording, press VCR, then press PAUSE k
once. The red RECORD light will flash. To resume
recording, press REC I or press PAUSE k again. The
red RECORD light will come on again.
6
To stop recording, press VCR, then press STOP C.
DISC
• A Timer Recording is not possible
during DVD to Videotape
duplication.
• You cannot select Tuner mode
during DVD to videotape
duplication.
• The recording will not be clear if
the DVD has copyright protection.
Helpful Hints
STANDBY-ON
TIMER SET
VCR/TV
SEARCH MODE
REPEAT
TUNER
3
456
789
SLOW
0
+10
2
1
VCRDVD
CLEAR
DISPLAY
SETUP/
PROG
TITLE RETURNMODE/SPEED
C-RESET
AUDIO/
BAND
ANGLE
SUBTITLE
ZOOM
DISC
MENU
OK
PAUSE
REW FF
PLAYSTOP
SKIP/
CH
SKIP/
CH
REPEAT
SOUNDSURROUND
+–
VOLUME
REC
A-B
4
4
3,5
2
5-6
5
1
6
E9000(P01-54).QX33.latest 03.6.5 2:51 AM Page 41