Filter
Top Products
34 Timer Recording with the VCR Plus+ Programming System
• If you enter an incorrect PlusCode
programming number at step 4,
ERROR-RE-ENTER CODE will flash
on the screen after step 5. Enter the
correct PlusCode programming num-
ber.
Helpful Hint
Follow the steps below to program a timer recording using
PlusCode programming numbers. Before you begin make sure:
• Channels are set up. Details are on pages 11-12.
• The clock is set. Details are on pages 13-17.
• There is a tape in the VCR. Make sure the tape’s record tab is
intact and the tape is long enough to record the program(s).
• The VCR is in VCR position (the VCR light will appear on the
display panel). If the VCR light does not appear, press the
VCR/TV button once.
• You have programmed the VCR Plus+ and Cable/TV channel
numbers. Details are on pages 32-33.
Complete each step within 60 seconds of completing the
previous step. If you don’t, you may start again at step 1.
1
Press the VCR button.
2
Press the TIMER button.
4
Use the Number buttons to enter the PlusCode program-
ming number of the program you wish to record. (This
number is different for every program.)
3
Press the PLAY 8 or STOP 9 button to select VCR
PLUS+, then press the FF :/OK button.
VCR PLUS+ PROG. CODE
VCR PLUS+ L
TO END PUSH EXIT
VCR PLUS+ PROG. CODE
VCR PLUS+ 1234L
TO SET PUSH >/OK
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
SELECT , 9 CHOOSE >/OK
→ VCR PLUS+
QUICK PROGRAMMING
PROGRAM REVIEW
TO END PUSH EXIT
1
2
4
3
VCRTV
VCR/TV
QUICK PROGRAMMING
POWER
STILL/SLOW
EJECT
CHVOL
EXIT/STATUS
TIMER
SMARTPICTURE
SKIP SEARCH INDEX AUDIO/MUTE
MENU
-
+
CBL / DBS
1 2 3
4 5 6
7 8 9
START STOP DATE
DBS DAILY
PLAY
REW FF
STOP
WEEKLY
/OTR
RECREC
-
+
-
+
SPEED
0
CLEAR
.............
.............
........
........
/OK