Filter
Top Products
Fig.D-6
Wiring in Handle (R)
Fig.D-4 Fig.D-5
Receptacle
Switch
Switch
Connect Receptacles
with Lead wires
as drawn on the right.
Controller
Terminal
Handle (R)
Controller
Put Controller in Handle (R).
Connected Receptacles to Terminals as drawn below.
Wiring to Terminal
Terminal
Receptacle
Receptacle
Handle (R)
Lead wire
(white)
Lead wire
(red)
Fig.D-3
1. Place DC motor in Motor housing (L). 2. Fix Lead wires with Line filter
(if used) in these Lead wire holders
by pushing them in the direction
of the arrows.
Wiring in Motor housing set
3. Mount Motor housing (R)
to Motor housing (L).
Wire connecting
portion of
Receptacle
Motor housing (L)
Lead wire
(red)
Lead wire
(black)
Line filter
(if used)
Motor
housing (R)
Motor housing (L)
Circuit diagram (cont.)
P 10/10
Do not route Lead wires over these ribs.
red dot
marking