Filter
Top Products
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Base
DISASSEMBLING
ASSEMBLING
M5-8
Hex lock nut
Wrench 8
(1) The machine is fixed to Base assembly with M5x10 Thumb screw at the rear side, and with M5 (+) Pan head screw
and M5-8 Hex nut at the front side. Separate the machine from Base assembly. (Fig. 2)
(2) Remove Angular guide and Depth guide. (Fig. 3)
Base can be now replaced with new one.
M5 (+) Pan head screw
Flat
washer 5
Depth guide
Spring washer 5
Angular guide
Angular Guide
1. Remove M5x10 Thumb screw,
Spring washer 5 and Flat washer 5.
2. Disassemble the hinge portion by
removing Stop ring E-3 and Pin 5.
Depth guide
Disassemble the hinge
portion by removing
Stop ring E-3 and Pin 4.
Base
Stop ring E-3
M5x10 Thumb screw
Spring washer 5
Flat washer 5
Base
Depth guide
Stop ring E-3
Depth guide
Pin 4
(1) Fix Depth guide to Base with Pin 4 through Depth guide and Base
from the external side. Secure them with Stop ring E-3. (Fig. 4)
(2) Fix Angular guide to Base with Pin 5 through Angular guide and Base
from the internal side. Secure them with Stop ring E-3. (Fig. 3)
(3) Fix M5x10 Thumb screw through Spring washer 5 and Flat washer 5
to Base and Angular guide. (Fig. 3)
(4) Assemble Base to the machine. (Fig. 2)
Pin 5
M5x10 Thumb screw
Loosen M5 (+) Pan head screw
while holding M5-8 Hex lock nut
with Wrench 8.
Unscrew M5x10 Thumb screw
from Depth guide.
Note: Be careful not to lose Spring
washer 5 and Flat washer 5.
Fig. 2
Fig. 3
Fig. 4
P 3/ 10
Repair
Stop ring E-3
Pin 4