Filter
Top Products
5
We recommend that you familiarize yourself with the remote control handset prior to installing the receiver.
INSTALLATION
For digital quality picture, connect the receiver to your TV using a fully wired SCART lead. If using the UHF TV
OUT connector then follow below step.
TUNING YOUR TV TO OUTPUT SIGNAL
Connect your TV using a co-axial lead and switch on the receiver. After initialising the digit LED (F2) will
display “NOCH”. Select a spare channel on your TV and tune it until you see the following OSD Settings
menu. Finally store the settings on your TV.
MAIN MENU
When you press the MENU key the main menu will appear on your screen wherein you can configure all your
settings.
Language: Select the required OSD language.
Transparency: Adjust transparency of channel banner and channel list.
Info-Display: Select display time of the channel banner. If you select On it will
remain on until exit key is pressed.
Audio Lang / Subtitle Lang: Select default language. This sets all channels to
that language
Screen Saver: Select time to turn ON screen saver in radio mode. After the
seconds have lapsed, the screen will change to revolving radio banner.
STORE: After above settings move to store and press OK key.
To select, press CH up / down or VOL up / down key. To enter a
menu, press OK key.
OPERATION IN PROGRAMMING MODE
The menus are designed to assist you from the
moment you switch on the receiver. Follow
the help
messages at the bottom of the menu.