Filter
Top Products
8
€˜ TP All + D -- Selected TP for all Video, Radio and Data channels.
€™ TP FTA -- Selected TP for Free to Air Video and Radio channels.
€š Manual All – Single TP for all Video and Radio channels. To select go to TP Data and press OK for
sub menu.
€› Manual All + D – Single or user defined TP for all Video, Radio and Data channels.
€œ Manual FTA – Single or user defined TP for Free To Air Video and Radio channels.
If you have added a TP, this will appear at the end of the list. Repeat above steps for all the satellites you wish
to search
LNB Skew: If you have set LNB Power to 14 0r 18 volts with Skew on then you can adjust the LNB Skew in
this menu. Press VOL up / down key to adjust. To adjust step by step, press and release the key. The skew
that you have set will be stored automatically after START has been activated.
NOTE: SIGNAL AND QUALITY (Channel Search Menu)
In channel search, the signal and quality conditions shown are as below.
€¡ Blue: Indicates noise only with no actual signal
€¢ Green: Indicates actual signal
€£ Quality: Green shows the quality of the signal
Positioner: Move down to Positioner and select DiSEqC USALS
Now go to START and press OK key. The antenna will move to the first satellite in the index and Searching
will start. After completing channel search, it will automatically scan and search the next satellite in the index.
This process is repeated until all satellites in the index are searched.
CHANNEL SEARCH: Manual Scan and Search
Configure Channel Search as described earlier then go to Positioner and select DiSEqC 1.2 If you only have
a fixed antenna, then select None. Move the antenna until you find the correct position, maximum signal and
quality and store the position
START: Press OK to start search.
Using a mechanical polarizer for your lnb
For fixed antenna installation, follow below steps. Connect the appropriate leads as shown on the output terminals (R13,
R14 and R15) at the back of the receiver. In INSTALL menu, go to Antenna Settings to configure below settings.
ANTENNA 1
€¤ Antenna: Select reference 1
€¥ LNB Type: Select Wide and press OK to configure LO settings if different.
€¦ LNB Power: Select 14V Skew On. This will switch your LNB to lower band.
ANTENNA 2
ۤ Antenna: Select reference 2
۬ LNB Type: Select Wide and press OK to configure LO settings if different
۩ LNB Power: Select 18V Skew On. This will switch your LNB to higher band.
ۻ 22KHz Tone: Select tone option if required.
€« STORE: Store the settings.
To select press VOL up / down. To edit or add, follow below settings
.
To add select User Defined.
Freq: Enter using 0-9 keys.
Polarity: Select polarity
S / R: Enter using 0-9 keys
FEC: Select FEC
Video PID / Audio PID / PCR PID Enter the channel PID using 0-9 keys
STORE: After above settings move to store and press OK key.
When searching, this page will show the TV and Radio channels being
downloaded.
After completing the index, the positioner will move the antenna to the first
satellite.
USING A MECHANICAL POLARIZER FOR YOUR LNB