Filter
Top Products
- 57 -
Via the Euroconnector
Your TV set has 2 Euroconnector sockets. If
you want to connect peripherals (e.g. video,
decoder, etc.) which have Euroconnectors,
to your TV, use SCART - (AV1 / AV2) input.
If an external device is connected via Euro-
connector sockets TV is switched to AV
mode automatically. In this case if both
sockets are connected SCART-1 has the
precedence.
Via Ant Input
If you want to connect to your TV, peripherals
like video recorders or decoders, but the de-
vice you want to connect does not have
Euroconnector, you should connect it to the
ANT input of your TV set.
If the VCR is connected via antenna input
it is suggested to use the Programme 0.
Decoder
Cable TV offers you a wide choice of
programmes. Most of them are free, others
are to be paid for by the viewer. This means
that you will need to subscribe to the broad-
casting organisation whose programmes
you wish to receive. This organisation will
supply you a corresponding decoder unit to
allow the programmes to be unscrambled.
For further information ask your dealer. See
also the booklet supplied with your decoder.
Connect a decoder with an aerial socket
to the TV
Connect the aerial cable.
Connect a decoder without an aerial
socket to the TV
Connect the decoder to your TV with a
eurocable (RCA Jack Cable) to SCART -
(AV1 / AV2) (RCA Jack). When your decoder
has a Euroconnector / RCA Jack you can
obtain better picture quality if you connect a
eurocable (RCA Jack Cable) to SCART -
(AV1 / AV2) (RCA Jack).
TV and Video Recorder
Connect the aerial cables.
Better picture quality can be obtained if you
also connect a eurocable to SCART - (AV1 /
AV2) sockets.
Playback NTSC
Connect NTSC VCR player to one of two
Euroconnectors at the back of the TV.
Then, press AV button to select AV-1 or
AV-2.
Search for and store the test signal
of the video recorder
Unplug the aerial cable from the aerial
socket ANT of your video recorder.
Switch on your TV and put the video recorder
on the test signal. (See the handbook for
your video recorder.)
Search for the test signal of your video re-
corder in the same way as you searched for
and stored the TV signals. See Install,
Search and Store TV channels. Store the
test signal under programme number 0.
Replace the aerial cable in the aerial
socket ANT of your video recorder once
you have stored the test signal.
Camera and Camcorder
To connect to (AV-3) input
Connect your camera or camcorder at the
back side of your TV.
Connect your equipment to the TV via VIDEO
(yellow), AUDIO R (red) and AUDIO L (white)
inputs. You should connect the jacks to the
input in the same colour.
Connect the decoder to the video
recorder
Some video recorders have a special
euroconnector for decoder.
Connect a eurocable to the euroconnector of
your decoder and to the special
euroconnector of your video recorder. See
also the handbook of your video recorder.