Mitsubishi Electronics SR-HD5 TV Receiver User Manual


 
Mitsubishi SR-HD5 HD DIRECTV Plus Receiver
Page 2-14
Connecting the VCR Control Cable
With the proper connections the HD receiver can control your VCR for
unattended recording.
Note: The output of the HD receiver must be in SD mode
to record using the hookup configurations previously
described in this chapter.
Finding the VCRs Remote Control Sensor
Plug the VCR control cable into the back of the HD
receiver. So that the HD receiver can control your
VCR, the emitter end of the VCR control cable must
be attached where the VCRs remote control sensor
is located. This is labeled on some VCRs. You may
also find a diagram in your VCR manual indicating
the sensor position. It is commonly identifiable by a
small dark plastic window. For reference, see the
sensor on the HD receiver located behind the door.
If the sensor is not labeled or documented, you will
need to scan the front of your VCR with your VCR
remote control. Use the following procedure to
accomplish this:
Hold the VCR remote control about ½-inch
from the front left side of your VCR.
Slowly move the remote control to the right repeatedly pressing the remote controls
key on and off.
Once the VCR responds to pressing the key on the remote control, note the posi-
tion of the remote control. This should indicate the location of the VCR remote control
sensor.
Once the sensor position has been determined, temporarily attach the emitter to the area with a
piece of tape until the system can be tested. Refer to the VCR Setup subsection in Chapter 7,
HD Receivers Menu System, to program and test the VCR control feature.
Upon verifying that the VCR control is functioning properly, you can remove the tape and
permanently attach the emitter using the peel-and-stick backing. This attachment should not
interfere with normal VCR operation.
RF Remote Control Receiver
Your HD receiver includes a Whole House RF remote control and RF remote control receiver.
With this combination you can have complete control of your HD receiver from other rooms
inside your house. The Whole House RF remote control emits a powerful radio signal that is then
broadcast up to a distance of 100 feet to the RF remote control receiver. No tools are needed to
install the RF remote control receiver. The range of the Whole House RF remote control is a
maximum of 100 feet, however weakened batteries and some building materials in walls, floors,
and ceilings may reduce this range.
The VCR Control
cable and jack
Look for indications of the remote control
sensor
Scanning for the remote control sensor
POWER
POWER