Mitsubishi Electronics HS-U448 VCR User Manual


 
30
1 Connect the audio cable to AUDIO OUT L
and R on the playback VCR and to AUDIO
IN L and R on the HS-U448. If the playback
VCR is mono, use only the AUDIO IN L on
the HS-U448.
2 Connect a video cable to VIDEO OUT on
the playback VCR and to the VIDEO IN on
the HS-U448.
3 If the playback VCR is Hi-Fi, set the audio
monitor to Stereo.
4 Use INPUT to set the HS-U448 to External
L1 if you used the HS-U448 rear panel
jacks, or External L2 if you used the HS-
U448 front panel jacks.
Using Two VCRs to Copy
There are two basic ways to make a copy of a tape.
One way is to use the HS-U448 to record and another VCR for playback.
The other way is to use another VCR to record and use the HS-U448 for playback.
Regardless of which method you may choose, you will need one RCA audio cable and one RCA video
cable to connect the two VCRs. If you do not have these cables, they are available at your local electronics
dealer.
VIDEO IN
L/MONO - AUDIO IN - R
L
R
L
R
RECORDING PLAYBACK
HS-U448
AUDIO IN 2 R
AUDIO IN 2 L/MONO
AUDIO OUT L
AUDIO OUT R
VIDEO OUT
VIDEO
IN 2
Using the HS-U448 to record from another VCR
Editing Features
5 Put a blank tape into the HS-U448.
6 Put the tape you want to copy into the
playback VCR and find the cue point. Press
STOP if the picture starts playing.
7 On the HS-U448, press REC, then PAUSE.
8 On the playback VCR, press PLAY, then
PAUSE.
9 Press the PAUSE buttons on both VCRs at
the same time to begin copying the tape.
10 When finished, press STOP on both VCRs.