Mitsubishi Electronics L75-A94 CRT Television User Manual


 
3. TV Features 27
For assistance call 1(877) 675-2224
3 D Video, continued
Notes on Using 3D Video Settings
3D signals and 3D settings affect some TV functions.
Switch to a non-3D source to regain full TV operation.
If Source Format is set to Automatic or one of the
named 3D formats OR Source Format
is set to
Off
and
the 3D video source is HDMI 1.4a compliant (picture may
appear as 2D), the following limitations apply:
Picture adjustments are limited. To make picture
adjustments while watching normal 2D images from
the device, temporarily set Source Format to Off to
make the full range of adjustments accessible.
While receiving a 3D signal,
-The
FORMAT
key is disabled.
-The
INTERNET
key is disabled.
Other Options in the 3D Menu
Glasses
Control Off
Settings
The Off settings disable output
from the selected emitter. Use Off
in the unlikely event of IR interfer-
ence with other devices.
2D+ Depth When selected, generates a simu-
lated 3D image from an ordinary
2D image. Requires use of active-
shutter 3D glasses.
Watching 3D Video
Active 3D glasses are required. All glasses in use
at the same time must use the same control type.
Halogen lights, fluorescent lights, or direct sunlight can
interfere with operation of the glasses.
1.
Switch the TV to the 3D video device. Press
INPUT
then highlight the icon for the 3D video device. Press
ENTER
.
Note: Before watching 3D images from an internet
source, it is important to establish the internet
connection fi rst before enabling 3D mode.
2.
Press
MENU
and select the Picture > 3D Mode menu.
3.
For Source Format, select Automatic and press
ENTER
. Press
EXIT
to close the menu.
If the image looks correct, the device is HDMI
1.4a compliant; always keep the setting at
Automatic for this device.
For non-compliant 3D sources, open the
Picture > 3D Mode menu and select a source
format based on how the picture looks:
Side by Side
Two images, screen
split vertically
Top/Bottom
Two images, screen
split horizontally
Checkerboard
Blurry double image
(always required for
checkerboard signals)
4.
Press
EXIT
to close the menu.
5.
If the image does not appear correct
(e.g., objects
appear to be moving in instead of out),
open the
Picture > 3D Mode menu. Highlight the Reverse
setting for the current control type and press
ENTER
to add a check.
6.
When finished watching 3D video:
If your 3D video device is HDMI1.4a compliant,
keep the setting on Automatic.
If you manually selected a source format in the
Picture > 3D menu, open the menu again and
select Automatic or Off.